TekTite Strobe 4500 High-Intensity

In Stock
The DUAL 13-Watt high-intensity LEDs make the Tektite 4500 Strobe our brightest strobe light, and will run 60 + hours on a set of three C-cell batteries.
The photograph of multiple strobe and marking lights is only for the purpose of illustrating relative sizes and those other lights are NOT included with this light.

TekTite Strobe 4500 High-Intensity

TekTite Multifunction LED 3500 Strobe Light
TekTite Strobe 4500 High-Intensity TekTite Multifunction LED 3500 Strobe Light
  • DUAL 13-Watt LEDs makes an Ultra-Bright Strobe
  • 60+ hours on three C-cell batteries - or rechargeable
  • Twist on for activation - safety ORANGE color
  • Visible at the surface for several miles at night
  • {9.25 in} long - sturdy ABS and LEXAN® material

The DUAL 13-Watt high-intensity LEDs make the Tektite 4500 Strobe an ultra-bright strobe light, double O-ring sealed, depth rated to { 500 ft | 152 m }, will run 60+ hours on a set of three C-cell batteries and can also accept rechargeable Ni-Cad Batteries. Visible at the surface for several miles/kilometers at night, the initial flash rate is 120 flashes per minute with fresh alkaline batteries. Features durable military tough ABS and LEXAN® construction, twist on switch with non-slip grip, safety orange color body with sturdy attachment point for snap or lanyard. At { 9.25 in | 23 cm } long this strobe is too big to fit in most pockets. Three C-cell alkaline batteries and a { 15 in | 38.1 cm } Velcro strap are included, along with a limited LIFETIME Warranty from TekTite.

More Information
SKU TTI-1073
Brand TekTite
Weight 2.0000
Enable Hide Price No

How to use a twist-on handheld dive light or strobe

Before diving with a new twist on handheld, learn how to properly operate your light or strobe so you don't flood it. While it might appear obvious how to turn the light or strobe on, getting confused or uncertain about what direction to twist is the most common reason for floods.

  • Properly insert the batteries in to the body or in some cases in to a carrier that is then inserted in to the body. Pay attention to the markings. Most batteries load with the positive end pointing toward the light head but a few designs load with the positive end pointing away from the light head. If there is more than one battery and especially if there is a carrier, double check to make sure all batteries are oriented correctly. Failing to properly load batteries is the most common explanation for seemingly "dead-on-arrival" lights.
  • Hold the light head steady in one hand, then use the other hand to turn the body so that it screws in toward the head to activate. For most designs the motion of twisting the body will be clockwise, but a few designs are counter clockwise. Continue twisting the light body until the body just stops against the head and the light is on. Tighter is not better; it is the O-ring that makes the seal. Particularly for lights or strobes with a plastic body or head, over-tightening the two parts together can warp the sealing surfaces and cause a flood.
  • Turn the light off by reversing the direction of the activation motion at least one-half revolution and typically NO MORE THAN ONE FULL REVOLUTION. However, make at least one-half revolution past where the light does go off because just backing off slightly can cause the light to turn back on by itself when descending. Dry practice turning the light on and off several times by holding the light head steady in one hand while turning ONLY the body in the other hand. It's also a good idea to switch the hands holding the head and body to become familiar with these motions regardless of how the light is being held.
  • Each time before entering the water with the light, practice once more as a reminder of the twist motion and to verify the light is working. Make it a habit to do this while looking closely at the twist motion. Skipping this check is how floods often happen: the light hasn't been checked and the batteries are dead or inserted incorrectly. Once underwater, if the light does not come on when twisting it no more than one full revolution, then STOP twisting. If you are turning the wrong direction then continuing to twist will take only one or two more revolutions before breaking the O-ring seal and causing a flood.
  • Do not store any handheld light or strobe for extended periods with batteries remaining inside the device. This is especially true for alkaline chemistry batteries that sometimes self-discharge and then leak acid.


© Copyright 2009 to 2019 Dive Gear Express®
Message Icon
Message Icon