Dive Rite Remote Exhaust Elbow

$30.00
In Stock
SKU
DR-BC2750-xx
Dive Rite Remote Exhaust Elbow with Nut and Pull Cable in three lengths.

Dive Rite Remote Exhaust Elbow

Remote Exhaust Elbow Options
Remote Exhaust Elbow Options Detail of Cable Attachment Side View

These replacement remote exhaust pull-to-dump elbows are available in three common cable lengths: { 12 In | 30.5 cm }, { 16 in | 40.6 cm } (standard) and { 22 in | 55.9 cm }. The Dive Rite Remote Exhaust Elbow is compatible with Dive Rite, DGX and other technical wings with an opening of { 1.75 in | 4.4 cm }. Not compatible with SeaQuest, Scubapro, Hollis, Zeagle, OMS and other major brands.

More Information
SKU DR-BC2750-xx
Brand Dive Rite
Weight 0.200000

Replacing Air Cell Inflation Assembly Elbows

Removing and replacing an air cell elbow must be done correctly; otherwise damage may result. The most important thing to remember is to turn only the collar at the base of the hose elbow, and not the elbow itself. Turning the elbow results in either loosening or damaging the flanges that mate the elbow to the air cell bladder.

When installing or reinstalling the elbow, make certain the gasket is in place between the elbow flange and bladder flange. As you tighten the collar, avoid cross threading by first turning counterclockwise until you hear a click. As you begin turning the collar clockwise, you will feel the elbow seat into the flange and lock into one of several possible positions. If the elbow assumes the wrong position, loosen the collar, reorient the elbow and begin again.

After tightening the collar as far as it will go, fully inflate the air cell and check for leaks. The air cell should be able to remain fully inflated for several minutes without exhibiting any substantial air loss.





     
Message Icon
Message Icon