Divesoft SOLO Oxygen Analyzer

$429.00
In Stock
SKU
DS-8302
The Divesoft SOLO O2 Analyzer for all recreational NITROX divers offers a membrane keypad, an easy-to-read OLED display and intuitive controls.

Divesoft SOLO Oxygen Analyzer

Analyzer Display in Air
Analyzer Display in Air Divesoft | Analyzer SOLO O2
  • Nitrox analysis with Intuitive controls, OLED display and advanced software
  • Easy to read O2% content including MOD for preset ppO2, date and temperature
  • MOD values for PO2 at 1.2, 1.4, 1.6 bar for immediate reference
  • Easy one-button press on/off and automatic calibration

With easy one button calibration, the Divesoft SOLO O2 analyster includes integrated temperature and pressure sensors for accurate oxygen content analysis of Nitrox gas mixtures. The Divesoft SOLO case has a compact { 3.2 × 7.9 × 1.5 in | 85 × 205 × 40 mm }, lightweight { 0.93 lb 14.8 oz | 420 g } and durable body made from injection molded ABS/PC plastic, thus is ideal for travel. The SOLO analyzer offers a membrane keypad, an easy-to-read OLED display and intuitive controls. The USB-C connector makes it easy to program and takes less than 4 hours to fully charge.

To use, simply place the flow limiter into the gas intake port, and push into the DIN valve. Nominal gas flow rate is 0.2 L / min.

Includes a simple flow limiter for a standard DIN 200 or 300 bar valve, padded storage case and USB-C to USB cable. The SOLO comes with a 24 month warranty, 12 months on the sensor and rechargeable battery. Operation on a single charge is 120 measurements or 4 hours of continuous operation. The oxygen sensor is user replaceable. Typical life of the sensor is 36 to 48 months depending on usage and amount of oxygen being analyzed, but can be as little as 12 months in frequent shop use.

If your needs change, the Solo O2 can be later upgraded to the Solo Trimix. The $429.00 upgrade involves replacing the entire back of the analyzer, installing a helium sensor and changing the firmware. For these reasons, the Solo O2 unit must returned to a Divesoft service center for upgrade to a Solo Trimix by a Divesoft certified service technician.

More Information
Brand Divesoft
SKU DS-8302
Weight 1.500000
Tek Tip Warning Image WARNING

Although tolerant of ordinary non-condensing humidity and water resistant, no analyzer is waterproof. Operation of any analyzer in boat spray, even brief immersion in water, or damp storage such as with wet dive gear may cause corrosion of the internal electronics or deposits on the face of the sensor. The result can be erratic operation such as error codes, battery warnings, or possibly inaccurate analysis readings without any indication of a fault. Always operate and store your analyzer in dry conditions, and if you suspect the analyzer has been exposed to wet conditions then discontinue use until the equipment has been serviced.