Dive Rite Plain (Non-Exhaust) Elbow w/Nut

Rating:
93% of 100
Loading...
$9.50
In Stock
SKU
DR-BC2042
The plain BC elbow, preferred by experienced divers, can be used to replace a pull-to-dump elbow.

The Dive Rite Plain (Non-Exhaust) Elbow w/Nut

This assembly is compatible with Dive Rite, DGX, Oxycheq, Halcyon, Light Monkey and other technical wings with an opening of {1.75 in | 4.4 cm}. Not compatible with SeaQuest, Scubapro, Hollis, Zeagle, OMS and other major brands.

More Information
SKU DR-BC2042
Brand Dive Rite
Weight (lbs) 0.2000
Customer Reviews
Most Helpful Customer Reviews
  1. Repaired my $60 BCD from Ebay

    By

    on

    There are a lot of BCD's being sold on Ebay, Zeagle where there elboy connection failed. These parts repaired the problem!
    Comment Was this review helpful to you? Thank you for your feedback! You already voted Sorry, we failed to record your vote. Please try again
  2. Very good product and service

    By

    on

    Very good product and service
    Comment Was this review helpful to you? Thank you for your feedback! You already voted Sorry, we failed to record your vote. Please try again
  3. But doesn't seal properly

    By

    on

    But doesn't seal properly
    Comment Was this review helpful to you? Thank you for your feedback! You already voted Sorry, we failed to record your vote. Please try again
  4. bc inflation elbow fits seaquest

    By

    on

    Great but doesn't fit mares or zegael
    Comment Was this review helpful to you? Thank you for your feedback! You already voted Sorry, we failed to record your vote. Please try again
  5. Fast shipping..great service as always

    By

    on

    Took about a week to get to me in Australia.
    Comment Was this review helpful to you? Thank you for your feedback! You already voted Sorry, we failed to record your vote. Please try again
See all 6 reviews
Post a comment as
Only registered users can write comments. Please, Sign in or create an account
Only registered users can write reviews. Please, Sign in or create an account

Replacing Air Cell Inflation Assembly Elbows

How to Turn an Elbow Elbow, Gasket, Flange

When removing and replacing an air cell elbow, it is important this task be done correctly; otherwise damage may result.

The most important thing to remember is to turn only the collar at the base of the hose elbow, and not the elbow itself. Turning the elbow results in loosening the flange that mates the elbow to the air cell bladder. Once loosened, this flange cannot be re-tightened, except with special tools. It is best to avoid any possibility of this happening by holding the elbow stationary, while turning only the collar.

When installing or re-installing the elbow, make certain the gasket is in place between the elbow and flange. As you tighten the collar, avoid cross threading the collar and flange. You will feel the elbow lock into one of eight different positions. If the elbow assumes the wrong position, loosen the collar, re-orient the elbow and begin again.

After hand tightening the collar as far as it will go, fully inflate the air cell and check for leaks. The air cell should be able to remain fully inflated for several minutes without exhibiting any substantial air loss.



Conditions of Use    Privacy Notice   

© Copyright 2009 to 2018 Dive Gear Express®