In Stock

> High Pressure Rubber Hoses

SALE - Bounce the rubber! - Upgrade to Double Braided Kevlar hoses for the same price as these rubber hoses!

Our high pressure hose is reinforced using double braided Kevlar, with a maximum working pressure of 5000 psi and a minimum burst pressure of 20,000 psi. The typical HP hose is a 7/16-inch male at the end that screws into the first stage HP port and a 7/16-inch female at the end that screws on to the SPG. The fittings are made from quality chrome-plated brass. Length is measured in inches, from end to end of hose, including the fittings and their threads.

Note that all high pressure hoses use an 'air spool' with two tiny o-rings to mate the swivel connector on the hose to the fitting on the gauge. The air spool is not included with the hose (see the price list below to order) but we recommend replacing the air spool when replacing the hose. The standard spool has the flange in the center as pictured at right but a few SPGs, typically the plastic body ones, may only accept a spool without a shoulder in which case you will have to reuse the air spool from the SPG.

In Stock

> BC Inflator Rubber Hoses

SALE - Bounce the rubber! - Upgrade to Double Braided Flexible hoses for the same price as these rubber hoses!

Our BC inflator rubber hose has a maximum working pressure of 320 psi and a minimum burst pressure of 1,600 psi. The typical low-pressure BC inflator hose is a 3/8-inch male at the end that screws into the first stage LP port, and at the other end is the Quick Disconnect BC female slide-lock Schrader valve fitting that accepts the standard BC inflator male QD post. The fittings are made from quality chrome-plated brass. Length is measured in inches, from end to end of hose, including the fittings and their threads.

In Stock

> Regulator Rubber Hoses

SALE - Bounce the rubber! - Upgrade to Double Braided Flexible hoses for the same price as these rubber hoses!

Our kink resistant low pressure regulator hoses are designed for extra long wear under normal operating use, with a maximum working pressure of 400 psi and a minimum burst pressure of 2000psi. They are suitable for use with all breathing gases including air, nitrox, trimix and oxygen, and have fittings made from quality chrome-plated brass. The typical low pressure regulator hose is a 3/8-inch male at the end that screws into the first stage LP port, and at the other end you'll find a 9/16-inch female that screws onto the second stage regulator body. Length is measured in inches, from end to end of hose, including the fittings and their threads.

In Stock

> LP and HP Hose Port Adapters

Most first stage high-pressure ports and hoses (including all the brands we carry) are 7/16-inch female. A few brands of first stages use high-pressure ports that are 3/8-inch female. We offer 3/8-inch to 7/16-inch hose adapters.

Most first stage low-pressure ports and hoses (including all the brands we carry) are 3/8-inch female. A few brands have a special low-pressure port that is 1/2-inch female, notably some Apex and older Aqualung models. We offer 1/2-inch to 3/8-inch hose adapters.